> AC Input Voltage: 90~264 Full Range 47Hz~63Hz.
> DC Output: 400W maximum

 

OUTPUT VOLTAGE	OUTPUT CURRENT		REGULATION	OUTPUT
	MIN(A)	MAX(A)	LOAD	RIPPLE & NOISE MAX.[P-P]
+5V	3	25	±5%	50mV
+12V	2	28	±5%	120mV
+3.3V	0.3	23	±5%	50mV
-12V	0.1	0.8	±10%	120mV
+5VSB	0.1	2	±5%	50mV

Note:
1. The combined total power from +5V and +3.3V shall not exceed 120W.
2. Noise Test – Noise bandwidth is from DC to 20 MHz.
3. Ripple frequencies greater than 1MHz shall be attenuated by the measurement System.
4. Add 0.1uF/10uF capacitor at output connector terminals for ripple and noise measurements.

 

> DIMENSION: L200 x W150 x H 86 mm
> COOLING: By forced air
> OPERATION TEMPERATURE: 0℃ to 50℃
> HOLD UP TIME: 16ms at maximum load & normal input voltage
> EFFICIENCY: ≧ 73﹪at full load. (Normal Line)
> ATX 12V / EPS 12V
> POWER-OK: PW-OK is power good signal and should be asserted high by the power supply to indicate that +5VDC and +3.3VDC output are above the under voltage thresholds of the power supply TTL. compatible signal out with 100ms to 500ms.
> OVER POWER PROTECTION: The power supply shall shut down when output power exceeds 130﹪to 160﹪ of full load and require a power on cycle be performed by the operate
> OVER VOLTAGE PROTECTION: Standard on +5.0V output, set at 6.25VDC ±0.75VDC.
> SHORT CIRCUIT PROTECTION: A short circuit placed between the DC Return and the output shall cause No damage and the power supply shall shutdown.
> EMI: FCC part 15, Subpart B, Class B, EN55022 CISPR22 Class B, CE Make, EN61000-3-3;1995, EN61000-4-2, -3, -4, -5, -6, -11
> AGAENCY APPROVALS: UL 1950 QQGQ2, UL 1950 QQGQ8, TUV Rheinland (EN60950, IEC950 mod), CB Certification
> MTBF OF POWER SUPPLY ELECTRONNIS: 100,000 hours. LIFE EXPCTANCY OF FAN 40,000 hours

 

20+4 Pin	P4 MB	Peripheral	FDD	8-Pin
X 1	X 1	X 7	X 1	X 1