|
MP2M-5435V 2U 435W IPC ZIPPY single PSU Features: Best Solution for Server ,Workstation ,Storage System . Dimension:
215x100x70(mm)
8.46x3.94x2.76(inch)
AC Input Specification: VOLTAGE： 90～264VAC FULL RANGE
FREQUENCY： 47～63HZ
INPUT CURRENT：6A (RMS) FOR 115 VAC/
3A (RMS) FOR 230 VAC
INRUSH CURRENT：40A MAX. FOR 115 VAC/
60A MAX. FOR 230 VAC DC output Specification:
Output Voltage/ Output Current Min./ Output Current Max./ Regulation Load/ Regulation Line/Ripple& Noise
+5V 1 25 ±5% ±1% 70mV
+12V 1 40 ±5% ±1% 120mV
-12V 0 0.8 ±10% ±1% 120mV
+3.3V 1 25 ±5% ±1% 70mV
+5VSB 0.1 3.5 ±5% ±1% 70mV
Features: * TEMPERATURE RANGE：OPERATING 0℃～40℃
* HOLD UP TIME：16mS MINIMUM AT FULL LOAD & NOMINAL INPUT VOLTAGE
* DIELECTRIC WITHSTAND：INPUT/OUTPUT 1800 VAC FOR 1 SECOND INPUT TO FRAME GROUND 1800 VAC FOR 1 SECOND
* EFFICIENCY：83% TYPICAL AT 115VAC , FULL LOAD
* POWER GOOD SIGNAL：ON DELAY 100mS TO 500mS，OFF DELAY 1mS
* OVER POWER PROTECTION：110～160% MAX
* OVER VOLTAGE PROTECTION：+5V→5.6V～6.6V +3.3V→3.6V～4.3V +12V→13.2V～15V
* SHORT CIRCUIT PROTECTION：+5V、+12V、+3.3V
* EMI NOISE FILTER : FCC CLASS A, CISPR22 CLASS A
* SAFETY : TO MEET UL, CUL, TUV
* REMOTE ON/OFF CONTROL THE POWER SUPPLY SHALL ACCEPT A LOGIC OPEN COLLECTOR LEVEL WHICH WILL DISABLE/ENABLE ALL THE OUTPUT VOLTAGE (EXCLUDE +5V STAND BY). AS LOGIC LEVEL IS LOW，OUTPUTS VOLTAGE WERE ENABLE， AS LOGIC LEVEL IS HIGH，OUTPUTS VOLTAGE WERE DISABLE.
* 3.3V & 5V REMOTE SENSING
* MEET IEC-1000-3-2 CLASS D
*THE POWER-SUPPLY IS FOR CHASSIS-ASSEMBLY ONLY AND IS NOT ALLOWED TO BE OPERATED AS STAND-ALONE COMPONENT. FINAL ASSEMBLY HAS TO COMPLY WITH CORRESPONDING EMC- AND SAFETY-REGULATIONS.
|
