DynaPower TC-1U46P80 1U Type 460 watt .

 

Features:

 

 INPUT SPECIFICATIONS
Input voltage: 90 to 264 VAC
Input frequency: 115V: 60Hz; 230V: 50Hz
Inrush current: 60Amps-peak/115Vac; 90Amps-peak/230Vac
Input current: 5Amps/115Vac; 3Amps/230Vac

OUTPUT SPECIFICATIONS
Over voltage protection: +5V output: 5.85V min, 6.82V max..; +3.3V output: 3.5V min., 4.5V max;
Overload protection: +5V: 50Amps; +3.3V: 50Amps; +12V: 22Amps;
Short circuit protection: The short circuit on any DC output shall not cause any damage to the power supply, including the primary fuse.

GENERAL SPECIFICATIONS
Hold-up time: 17ms at 115Vac/60Hz, 17ms at 230Vac/50Hz.
Efficiency: 80% min. 115/230Vac at full load
MTBF: 100,000 hours
Power good signal: 100ms to 500 ms

ENVIRONMENTAL SPECIFICATIONS
Operating temperature: 0˚C to +40˚C
Storage temperature: -20˚C to +80˚C
Relative humidity: 5% to 95% RH non-condensing

Specifications:

 

 Dimension : 220x 100 x 40.5 mm
> Application : For Server & Workstation
> ATX 12V / EPS 12V
> Watt : 460
> PFC : Active
> 80 PLUS
> High efficiency
> Low Ripple & Noise
> 100% burn-in under high ambient temperature(50˚C)
> 100% Hi-pot tested
> Complies with EN61000-3-2
> AC input full range

 

DC Output:

OUTPUT VOLTAGE	OUTPUT CURRENT		REGULATION		OUTPUT
	MIN ( A )	MIN ( A )	LOAD	LINE	RIPPLE & NOISE MAX. [P-P]
+5V	0.5	20	±5%	±1%	50mV
+12V1	1	16	±5%	±1%	120mV
+12V2	1	16	±5%	±1%	120mV
+12V3	1	16	±5%	±1%	120mV
-12V	0	0.5	±10%	±1%	150mV
+3.3V	0.5	20	±5%	±1%	50mV
+5VSB	0	2.5	±5%	±1%	50mV

 The +3.3V and +5V total output shall not exceed 150watts.
(2) total output for this subject power supply is 460 watts.
(3) Ripply and noise measurements shall be made under all specified load conditions through a single pole low pass filter with 20MHz cutoff frequency. Outputs shall bypassed at the connector with a 0.1uF ceramic disk capacitor and a 10uF electrolytic capacitor to simulate system loading.
(4) -5V is option.

 

Output Connectors:

 

DynaPower TC-1U46P80 1U Type 460 watt