|
THIS PART IS NOW DISCONTINUED. REPLACED BY 400W SS-1U40ES which can be found HERE DynaPower TC-1U30P80 1U Type 300 watt . Features: Dimension : 190 mm x100 mm x40 mm
> Application : For IPC
> ATX 12V / EPS 12V
> Watt : 300
> PFC : Active
> Voltage : 90 to 264 VAC
> Frequency : 47Hz to 63Hz
> Input Current : 115Vac / 6.3A max. 230Vac / 3A max.
> Inrush Current : No damage shall occur to the power supply and the fuse shall not open or exceed its maximum rating: 100A max @ 230Vac 25˚C cold start.
> Remote ON/OFF Control : TTL High/PS-OFF; TTL Low/PS-ON
VIL=0.8Vmax, IIL=-1.6mAmax @Vin=0.4V
VIH=2.0Vmin @Iin=-200uA, VIH=5.25Vmax @open ckt
> Operating Temperature : 0˚C to +50˚C
> Storage Temperature : -20˚C to +60˚C
> OPERATING HUMIDITY 10% to 90%,non-condensing at 40˚C
> STORAGE HUMIDITY 5% to 95%, non-condensing at 50˚C
> Hold-up Time : 16 msec (minimum) at 80% of full load at 115Vac input.
> Power Efficiency :80% (min.) at 20%,50%,100% loading line input
> MTBF: 100kHrs Minimum. Specifications: AC Input:
> Output over voltage protection
> Short circuit protection on all output
> 100% burn-in under high ambient temperature
> The power supply shall withstand the following ESD conditions at any point on the power supply
> 100% Hi-pot tested
> Line input fuse protection
> With 4cm fan
DC Output:
Output Voltage | Min. load | Max. load | Load Reg. | Ripple & Noise |
+5Vsb | 0.0A | 2.5A | ±5% | 50mV P-P |
-12V | 0.0A | 0.8A | ±10% | 120mV P-P |
+12V1 | 1A | 18.0A | ±4% | 120mV P-P |
+12V2 | 0.5A | 18.0A | ±4% | 120mV P-P |
+5V | 0.5A | 16.0A | ±4% | 50mV P-P |
+3.3V | 1A | 16.0A | ±4% | 50mV P-P |
Note:
• The combined power of +12V1 and +12V2 is 288W max.It is 24A max.
• +3.3V &+5V total output not exceed 110W
• The continuous total output power is 300W max.
Output Connectors:
20+4 Pin | Peripheral | FDD | 4+4 Pin | SATA |
X 1 | X 3 | X 1 | X 1 | X 2 |
|
